AW-CTD382 is conventional photo-electronic smoke detector uses a state of-the-art optical sensing chamber. This detector is designed to provide open area protection and  to be used with most conventional fire alarm panel. The conventional rate of rise heat detector uses thermal component to detect the temperature  changing in the environment. It can enable fire alarm when the temperature difference achieved the  setting rate of rise temperature value. It can also enable fire alarm when the absolute  temperature value reach the setting fixed value. It has a stable and reliable working performance. Two LEDs on each detector provide local 360° visible alarm indication. They flash every six  seconds indicating that power is applied and the detector is working properly. The LEDs latch on  in alarm. LEDs will be off when a trouble condition exists indicating that the detector  sensitivity is outside the listed limit. The alarm can be reset only by a momentary power  interruption. The detector that initiated the alarm condition will have its red LED and relays latched until rest by panel. Standby Current ≤120uA@24VDC Maximum Alarm Current (LED on) ≤15mA@24VDC (1K Ohm current-limiting resistance) Operating Humidity Range ≤95%RH(40ºC±2ºC)RelativeHumidity,Non-condensing Operating Temperature Range -10ºC to 50ºC(14ºF to 122ºF) Fix Temperature Alarm 57ºC(135ºF)A2R Rate of rise Alarm 7.1ºC/5S A2R Height 48.2mm installed in Base Diameter 99.45mm Categories: Heat Detectors, Conventional Fire Alarm System
